Find Trade Colleges

General Drafting & Design Technology at Shelton State Community College

General Drafting & Design Technology at Shelton State Community College

If you plan to study general drafting and design technology, take a look at what Shelton State Community College has to offer and decide if the program is a good match for you. Get started with the following essential facts.

Shelton State Community College is located in Tuscaloosa, Alabama and approximately 3,743 students attend the school each year. During the the most recent year for which data is available, 11 students received their associate's degree in general drafting and design tech.

Want to know more about the career opportunities in this field? Check out the Careers in General Drafting & Design Technology section at the bottom of this page.

Shelton State Community College General Drafting & Design Technology Degrees Available

  • Basic Certificate in General Drafting & Design Tech (Less Than 1 Year)
  • Associate’s Degree in General Drafting & Design Tech

Shelton State Community College General Drafting & Design Technology Rankings

Note: Rankings don't always give a complete picture of a school's strengths and weaknesses, so it's a good idea to extend your research and also look at other factors when trying to decide if the school is right for you.

General Drafting & Design Tech Student Demographics at Shelton State Community College

Take a look at the following statistics related to the make-up of the general drafting and design tech majors at Shelton State Community College.

Shelton State Community College General Drafting & Design Technology Associate’s Program

45% Women
9% Racial-Ethnic Minorities*
For the most recent academic year available, 55% of general drafting and design tech associate's degrees went to men and 45% went to women. The typical associate's degree program in general drafting and design tech only graduates about 28% women each year. The program at Shelton State Community College may seem more female-friendly since it graduates 18% more women than average.

undefined

The majority of those who receive an associate's degree in general drafting and design tech at Shelton State Community College are white. Around 73% fell into this category, which is below average for this degree.

The following table and chart show the race/ethnicity for students who recently graduated from Shelton State Community College with a associate's in general drafting and design tech.

undefined
Race/Ethnicity Number of Students
Asian 0
Black or African American 1
Hispanic or Latino 0
White 8
International Students 0
Other Races/Ethnicities 2

Careers That General Drafting & Design Tech Grads May Go Into

A degree in general drafting and design tech can lead to the following careers. Since job numbers and average salaries can vary by geographic location, we have only included the numbers for AL, the home state for Shelton State Community College.

Occupation Jobs in AL Average Salary in AL
Architectural and Civil Drafters 1,140 $52,740
Mechanical Drafters 710 $56,960
Drafters 240 $42,790
Electrical and Electronics Drafters 200 $55,550

References

*The racial-ethnic minorities count is calculated by taking the total number of students and subtracting white students, international students, and students whose race/ethnicity was unknown. This number is then divided by the total number of students at the school to obtain the racial-ethnic minorities percentage.

More about our data sources and methodologies.

Find Trade Schools Near You

Our free school finder matches students with accredited trade schools across the U.S.